FUNC=PIO0_19, MODE=INACTIVE_NO_PULL_DO, INV=INPUT_NOT_INVERTED_, OD=DISABLE_, HYS=DISABLE_, SLEW=SLOW
I/O configuration register for pin PIO0_19/CLKIN/ CLKOUT/ MOSI0/CT16B1_MAT0
| FUNC | Selects pin function for pin PIO0_19/CLKIN/ CLKOUT/ MOSI0/CT16B1_MAT0 0 (PIO0_19): General purpose digital input/output pin. 1 (CLKIN): External clock input. 2 (CLKOUT): Clock output. 3 (MOSI0): Master Out Slave In for SSP0. 4 (CT16B1_MAT0): Match output 0 for 16-bit timer 1. |
| MODE | Selects function mode (on-chip pull-up/pull-down resistor control). 0 (INACTIVE_NO_PULL_DO): Inactive (no pull-down/pull-up resistor enabled). 1 (PULL_DOWN_RESISTOR_E): Pull-down resistor enabled. 2 (PULL_UP_RESISTOR_ENA): Pull-up resistor enabled. 3 (REPEATER_MODE_): Repeater mode. |
| HYS | Hysteresis. 0 (DISABLE_): Disable. 1 (ENABLE_): Enable. |
| INV | Invert input 0 (INPUT_NOT_INVERTED_): Input not inverted (HIGH on pin reads as 1, LOW on pin reads as 0). 1 (INPUT_INVERTED_HIGH): Input inverted (HIGH on pin reads as 0, LOW on pin reads as 1). |
| RESERVED | Reserved. |
| SLEW | Driver slew rate 0 (SLOW): Slow. More outputs can be switched simultaneously. 1 (FAST): Fast. |
| OD | Open-drain mode. 0 (DISABLE_): Disable. 1 (OPEN_DRAIN_MODE_ENAB): Open-drain mode enabled. This is not a true open-drain mode. Input cannot be pulled up above VDD. |
| RESERVED | Reserved. |